NX NASTRAN Product Analysis

NX NASTRAN Product Analysis

First go to New > Model click of model… it opens the window.
Now go to Insert > Sketch in Task Environment… it opens the sketcher environmental window.
Now select the plane and sketch a figure by specified dimensions

- Here I sketch rectangle with specified dimensions and click of FINISHED SKETCH.

- Now select the Extrude by specified dimensions and create some holes of the part by specified diameter.

- Now create the Blend Edge on the part by specified dimensions and save the part file inside any new folder.

Now go to Start > Advanced Simulation… it opens the NX Nastran window.
Menu Manager is opened under name Simulation Naviga… here the part is displayed the Menu Manager for example ‘model 1’.
Right Click on ‘model 1’. And select New FEM and SIMULATION option.
Now a Menu Manager is open of New FEM and SIMULATION here we must enable Geometry Options which we are looking for and close the menu
After closing the Geometry Options Menu Manager. It opens another Menu Manager which is Solution Menu Manager here we enable the Case Control as per our requirement and select the Solution type Analysis type solver then click on OK.
Now select Fem Idealization from the Simulation File Manager.

-Here Promote the part and Idealize part with Idealize Geometry only holes and Blend can idealize here.

-Here assume the material on Asign Materials and Mesh > 3D Tetrahedral by selecting polygonal face the dashboard.

11. Now select Sim option in Simulation File Manager.

- Here give the Constrain type as Fixed Constraint and load type as Force.

12. Now click on the Solve Icon it’s finally shows the Job finished and then close it.

13. Now generate the Report of this part by clicking on Create Report icon

14. Now go through the result.

Total Pageviews